Product quality control is one of the most important phases of technological cycle of aluminum and PVC profile extrusion. Finished or semifinished profile is subject to geometry control several times at different manufacturing steps. Thorough control is needed to detect defective products or extrusion equipment failures. 

A lot of extrusion companies still use only manual measurement in their quality control. However caliper and precision angle is not enough to comply with modern accuracy and measurement speed requirements.


FREE
TRIAL
PERIOD

System


Scanfex Profile Geometry Control System has been developed to eliminate human factor and errors from measurement process and speed up profile control procedure.

The system automatically measures all samples’ dimensions, compares obtained data with drawing and shows exceeded tolerances (if any) on computer screen. The entire control procedure is launched with a single mouse click.